Volden Expanding Gun grade Gap filling Adhesive foam 750ml

Product information

Fast drying polyurethane adhesive, used for the bonding of plasterboard onto walls to all common building substrates. Gun Applied

• Strong bond strength
• CFC-free
• Causes skin irritation- May cause an allergic skin reaction, Causes serious eye irritation, Harmful if inhaled, May cause allergy or asthma symptoms or breathing difficulties if inhaled, May cause respiratory irritation, Suspected of causing cancer, May cause damage to organs through prolonged or repeated exposure, Extremely flammable aerosol, Pressurised container: May burst if heated
• Instructions for use: Preparation: Do not apply below +5°C. or above +35°C. When applying in cold conditions allow the canister to reach room temperature. The surfaces must be clean, free of loose particles and free of dust and grease. Always wear gloves and suitable clothing as cured foam is extremely difficult to remove. Protect sensitive nearby surfaces from stray foam by covering them. Remove all sources of ignition and isolate switches that might cause sparks. In cold temperatures, leave the foam at least one hour before use in warm to room temperature. Among others, not recommended for use on silicone, PTFE, PP, PE and greasy or oily surfaces. Adhesion tests prior to application are recommended. It is the user’s responsibility to determine suitability. Application: 1. Turn the can of foam upside down and fix onto the applicator gun ensuring that the threads are lined up. 2. Shake the can at least 30 times before use. 3. Regulate the flow of foam by loosening the valve at the back of the handle. 4. Check there are no sources of ignition present. 5. Keep the can upside down during extrusion. When not in use for a long period close the extrusion screw. Do not remove can from gun as this will cause the foam to cure in the gun. 6. Whilst fixing boards, foam adhesive should be applied onto the board itself, ideally in vertical strips at intervals of approx. 30cm. 7. Wait 5-10 minutes after application before pushing the board firmly into place. The higher the temperature, the shorter the cure time. Boards should be supported in place until the adhesive is fully cured. 8. Clean gun after use with suitable foam cleaner.
• Not crack resistant
• Moisture resistant
• Guarantee of Statutory

Features and benefits

• Ideal to fill cavities and bonding plasterboard to walls
• Can be used to bond insulation
• Foam Gun Application
• Fast drying Polyurethane adhesive 
• Sustainable airtight building solution
• No electricity required
• Reduces storage space on building sites