See more Glues & adhesives
UniBond Specialty Rubber Not water resistant Solvented Clear Adhesive 30g 0.03kg
€
6.10
€
203.33
per kg
UNDER
18
Checking availability...
Product details
Product information
Speciality adhesive for rubber
- Surfaces must be close fitting, clean, dry and free from dust, grease or paint. Apply a thin, even coat of adhesive to both surfaces, especially at the edges, using a serrated spreader or clean, short bristled brush. Ensure the entire surface to be bonded is covered. For best results, apply adhesive at a temperature of 18°C to 25°C. Replace the cap immediately. Allow the adhesive to dry for approximately 15 minutes until touch dry. Carefully align the parts and press together. Apply firm pressure for a few seconds from the centre of the bonded area outwards. Bonding will be instant and not repositionable, provided full strength within 24 hours
Features and benefits
- Store tube in blistercard in cool and dry condition
Health and safety
Please note that this item has additional safety or regulatory datasheets available. The product may have possible health and safety hazards covered in these documents. Refer to the container for full information and always follow the instructions.
UNDER
18
Specifications
Application method | Tube |
---|---|
Colour | Clear |
Container type | Tube |
Drying time | 24 h |
Location | Interior & exterior |
Minimum application temperature | 18°C |
Sandable | Non-sandable |
Solvent-free | Solvented |
Volume | 30ml |
Weight (g) | 30g |
Product code | 5010383318208 |