Guide for Quarry Tile Grout |
Quarry tile grout, for quarry tiles, comes in ready-mixed and powder
form. Some prefer to use the powder and it is easily mixed, in a
bucket, in quantities that you can easily work with. Apply a liberal
amount of grout to the tiles, and then spread it, pushing into the
gaps in a regimental way.
Make sure each tile gap is filled as it will
sink late if not. A grout trowel may be used for this process but in
tight corners I would recommend the use of a sponge.
When an area has been covered of approximately 3m x 3m, wipe off all
excess grout with the sponge. Rinse out the sponge well in a separate
bucket full of water. You may be required to repeat this process
several times to remove all the excess grout from the surface of the
tiles.
Tile grout can dry quite quickly, and you will probably find a very
thin dust residue on the surface of your tiles. This can be polished
off easily with a dry cloth.
More Info
For more information on this topic please return to tips categories and select from the sub-category menu.
We hope you find this information both helpful and educational with regard to grouting tiles.
Thank you for your visit today we are constantly adding and updating our material so please visit with us again.
|
|
|
News
Hints & Tips
Competitions
|