Klenova Black Wired Bulkhead light, Pack of 1
Product Features
- Designed for use in basements, garages or attics
- Outdoor oval flush light with decorative cage guard in a black finish and ribbed glass
Electrical recycling service
Thinking about buying a new electrical product from us? Find out about our electrical recycling service here
Product details
Product information
Product information
This Klenova black framed bulkhead light is the perfect low light for supporting and illuminating areas such as your basement, garage or attic. It provides a neutrally toned and high intensity brightness as well as a large beam angle.
- Bulb not included
- Non-dimmable
- Fittings & fixings included
- Guarantee - Statutory
Features and benefits
- Designed for use in basements, garages or attics
- Outdoor oval flush light with decorative cage guard in a black finish and ribbed glass
Specifications
| Bulb type | GLS |
|---|---|
| Cap fitting | Edison screw cap (E27) |
| Depth (mm) | 106mm |
| Fire rated | Not fire-rated |
| Fire rating | Not fire-rated |
| Glass finish | Clear |
| Height (mm) | 106mm |
| IP rating | IP44 |
| Material | Glass & plastic |
| Maximum bulb wattage | 60W |
| Motion sensor | Without motion sensor |
| Number of bulbs | 0 |
| Power output | 60W |
| Power source | Mains-powered (wired) |
| Power voltage supply | 220-240V |
| Style | Traditional |
| Width (mm) | 122mm |
| Wiring required | Wiring required |
| Product code | 5063022044747 |
Documents
Product Instruction Manual
Safety Information
These instructions are for your safety. Please read through them thoroughly prior to installation and retain them for future reference
All fittings must be installed by a competent person in accordance with local regulations (IET wiring regulation BS7671).
Check the pack and make sure you have all of the parts listed.
Remove all packaging, wrap etc from the product.
Decide on the appropriate location for your product.
CAUTION: IP44 is guaranteed when the product is properly installed and sealed.
Always avoid the product to be located at corrosive environment.
Always refer to the installation drawing for the orientation of the product.
The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only. Other fixings not supplied and must be purchased
Take care not to drill into any pipes or mains cables beneath the surface during mounting holes preparation
Manufacturer / EU responsible person
Manufacturer
Kingfisher International Products B.V.
Address
Rapenburgestraat 175, E,
Amsterdam
1011 VM
Netherlands